Top 6 Best 250k Pots For Guitars

Genuine Fender Replacement Part. High Quality. Durable. Country of Origin United States.

Suitable for both tone and volume controls. 250K Ohms10 Tolerance. 18-tooth coarse knurl, .236 diameter shaft. Each pot comes with hardware - 2 nuts dress washer and lock washer. Manufactured by Bourns.

CTS 450 series is designed specifically for use in guitars. High quality brass bushing and brass shaft. Requires a 38 diameter mounting hole. 047uf 400V Polypropylene Capacitor. Radial Leads.

Genuine CTS pots, the brand used by nearly every American guitar company for half a century. 250k 10 audio-taper, mimics the logarithmic way humans perceive changes in volume better than any other taper.. 24-tooth knurled split-shaft, designed for plastic knobs that push on.. 38-32 bushing thread is 38 diameter, 14 long. For mounting to pickguards or control plates.. CTS low torque design dimpled back is easy to turn, this is the style used on Strats since the 1950s..

Fits for most USA electric guitar and bass. Fine 24-spline split shaft diameter 6mm 1564 inch, threaded diameter and height 9.5mm 38 inch. Made of full brass, better conductivity. Audio taper, resistance 250K, tolerance 20, usually used for single coil pickups, bleeds off some of the high frequencies to ground, gives warmer tone than 500K. Package included 3 pieces guitar potentiometers with mounting accesssories.

CTS 450G Series Made Specifically for Guitars - Solid Brass Bushing and Shaft. 250K Ohm Resistance, 10 Tolerance, Low Friction Rotation. Short Shaft 14 Inch Bushing Height, 14 Inch Diameter Solid Shaft. Each pot comes with hardware - 1X Nut, 1X Dress washer and 1X Lock Washer. Imperial Sized - NOT for import guitars using metric components.

These pots are widely used guitar tone and volume controls, good to fit small cavity. Metric sized pots mostly use in import guitar or Asia made guitar. 6mm knurled split brass shaft fits a coarse-knurled 18-spline knob. It will fit modern SquierEpiphoneibanezESP etc made in ChinaKoreaJapan guitar's stock knobs. Metric sized, Thread M8 x 0.8, Thread height 10mm 38, aluminum shaft. 16.5mm 58 mini sized base. Standard solid construction. Audio taper with standard 20 resistance tolerance, 250K-ohm pots are usually used for single-coil pickups. A 250K gives a slightly warmer tone than a 500K, and bleeds off attenuates some of the high frequencies to ground. Package included 4 pieces potentiometers, nuts and washers.

Audio Taper A increases or decreases in a sloped curve fashion Linear Taper B increases or decreases in a linear fashion Audio Taper A are always used as Tone and Linear Taper B are always used as Volume, but you can use Audio Taper as Volume and Linear Taper as Tone as well, it usually depends on your personal preference.. Long Split shaft with coarse knurling. Shaft Total Length about 17.5mm Knurled Shaft Diameter about 5.8mm Base Diameter about 24mm. Very hot quality metric guitar pots for most electric guitars. Package includes 5pcs Guitar pots with nuts and washers.

Fender original factory part. 250K split shaft. Includes nut, washer, and tonecapacitor. For use as a volume or tone control on single coil pickups.